Figure 92. Connecting the BOSS-N1 power and signal cables to the BOSS-N1 module
5. Connect the BOSS-N1 power and signal cable to the connectors on the system board.
6. Align the M.2 SSD module at an angle with the BOSS-N1 card carrier.
7. Insert the M.2 SSD module until it is firmly seated in the BOSS-N1 card carrier.
8. Using the Phillips 1 screwdriver, secure the M.2 SSD module on the BOSS-N1 card carrier with the M3 x 0.5 x 4.5 mm screw.
Figure 93. Installing the M.2 SSD module
9. Slide the BOSS-N1 card carrier into the BOSS-N1 module slot.
10. Close the BOSS-N1 card carrier release latch to lock the carrier in place.
118
Installing and removing system components
To Next Page
Loading...
