Table 69. Config: 8 x 2.5-inch NVMe Overview-3
Order From To
1 PSB1_CTRL_DST_PA1 (CTRL input connector) MB_IO_RISER1 (CPU1) (Riser 1 connector on
system board)
2 PSB1_CTRL_DST_PA2 (CTRL input connector) MB_SL13_CPU1_PB7 (signal connector on
system board) and MB_SL14_CPU1_PA7 (signal
connector on system board)
3 PSB2_CTRL_DST_PA1 (CTRL input connector) MB_SL7_CPU1_PB4 (signal connector on
system board) and MB_SL8_CPU1_PA4 (signal
connector on system board)
4 PSB2_CTRL_DST_PA2 (CTRL input connector) MB_SL3_CPU1_PA2 (signal connector on
system board) and MB_SL4_CPU1_PB2 (signal
connector on system board)
5 PSB3_CTRL_DST_PA1 (CTRL input connector) MB_SL1_CPU2_PA1 (signal connector on
system board) and MB_SL2_CPU2_PB1 (signal
connector on system board)
6 PSB3_CTRL_DST_PA2 (CTRL input connector) MB_SL5_CPU2_PB3 (signal connector on
system board) and MB_SL6_CPU2_PA3 (signal
connector on system board)
7 PSB4_CTRL_DST_PA1 (CTRL input connector) MB_SL11_CPU2_PB6 (signal connector on
system board) and MB_SL12_CPU2_PA6
(signal connector on system board)
8 PSB4_CTRL_DST_PA2 (CTRL input connector) MB_IO_RISER4 (CPU2) (Riser 4 connector on
system board)
Expansion cards and expansion card risers
NOTE:
When an expansion card is not supported or missing, the iDRAC and Lifecycle Controller logs an event. This does
not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the PowerEdge Servers Troubleshooting Guide at PowerEdge manuals.
108 Installing and removing system components
To Next Page
Loading...
