Figure 91. Installing the NIC air shroud
Next steps
1. Replace the PSB top cover.
2. If required, install the front PERC module.
3. Slide in the drive cage.
4. Connect the drive backplane cables to the connectors on the system board and backplane.
5. Replace the drives.
6. Replace the air shroud
7. Replace the cooling fan cage assembly.
8. Replace the front top cover.
9. Follow the procedure listed in After working inside your system.
10. Install any device drivers required for the card as described in the documentation for the card.
Removing the PCIe Base Board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Remove the drives.
7. Observe and disconnect the drive backplane cables from the connector on the system board and backplane.
8. Slide out the drive cage.
9. If required, remove the front PERC module.
10. Remove the PSB top cover.
11. Observe and disconnect the cables connected to PSB module from system board.
12. Remove the PSB module.
Installing and removing system components
123
To Next Page
Loading...
