Figure 171. Installing the HGX Management Controller card
Next steps
1. Replace the GPU top cover.
2. Replace the GPU tray.
3. Replace the GPU fan cage.
4. Follow the procedure listed in After working inside your system.
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to
the manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the front top cover.
4. Remove the cooling fan cage assembly.
5. Remove the air shroud .
6. Observe and disconnect the cables from the connectors on the power distribution board.
Steps
1. Press and hold the battery socket retention latch, for the battery to pop out. .
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
188 Installing and removing system components
To Next Page
Loading...
