Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the system cover.
4. Remove the air shroud.
5. Remove the cooling fan cage assembly.
6. Observe and disconnect the cables from the connectors on the power distribution board.
7. Remove the PSU cage.
8. Remove the BOSS cage.
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card toward the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
Figure 177. Removing the OCP card
4. If the OCP card is not going to be replaced, install a filler bracket .
Next steps
1. Replace the OCP card.
Installing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Installing and removing system components
195
To Next Page
Loading...
