Figure 95. Riser 3
1. Slot 1, x16, FH-HL (Full Height - Half Length)
2. Slot 2, x16, FH-HL (Full Height - Half Length)
Figure 96. OCP riser
1. x16 FLOP OCP Gen4 slot
NOTE: The expansion-card slots are not hot-swappable.
The following table provides guidelines for installing expansion cards to ensure proper cooling and mechanical fit. The expansion
cards with the highest priority should be installed first using the slot priority indicated. All the other expansion cards should be
installed in the card priority and slot priority order.
Table 100. Configuration 0: No Riser for Rear Accessed configuration
Card type Slot priority Maximum number of cards
Dell BOSS N1 card Module Integrated slot 1
Table 101. Configuration 1: R1+R3
Card type Slot priority Maximum number of cards
Dell BOSS N1 card Module INT 1
Pensando SmartNIC: 25GbE SFP28 2P
(FH)
1 1
124 Installing and removing system components
To Next Page
Loading...
