2. Follow the procedure listed in the Before working inside your system.
3. Remove the expansion card riser 1.
Steps
1. Align and insert the power button control panel in the slot on the system.
2. Route the power button control panel cable through the side wall of the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
3. Connect the power button control panel cable to the connector on the system board.
4. Using the Torx 8 screwdriver, tighten the screws that secure the power button control panel to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 142. Installing the power button control panel for Front Accessed configuration
Figure 143. Installing the left ear for the Front Accessed configuration
5. Using the Phillips 2 screwdriver, tighten the screws and secure the rack left ear.
Next steps
1. Install the expansion card riser 1.
2. Follow the procedure listed in the After working inside your system.
164
Installing and removing system components
To Next Page
Loading...
