Install expansion card riser 2
P
rerequisites
Follow the safety guidelines listed in Safety instructions on page 13.
Steps
To install expansion card riser 2:
a. Align the screw and tab on the riser with the screw hole and slot on the system.
b. Lower the riser into the system until the riser connector engages with the connector on the system board.
c. Using Phillips #2 screwdriver, tighten the screws to secure the riser to the system.
Figure 63. Installing expansion card riser 2
I
nstall expansion card riser 3
Prerequisites
Follow the safety guidelines.
Steps
1. Align the tab on the riser with the slot on the system, and guide rails on the riser with the standoffs on the side of the
system.
2. Lower the riser into the system until the riser edge connector engages with the connector on the system board.
The riser card edge engages with the riser guide on the system.
3. Using a Phillips #2 screwdriver, tighten the screw to secure the riser to the system.
120 Replace the system board
To Next Page
Loading...
