Remove the original CMA brackets
A
bout this task
The system rails may ship with CMA brackets already attached. If the brackets are attached, they must be removed.
Steps
1. Remove the two screws holding the CMA bracket to the rail.
Figure 74. Remove the original CMA bracket
2
. Repeat the previous step for the second rail.
Attach the new CMA brackets
About this task
The brackets are labeled left and right, and cannot be interchanged. The top of each bracket is labeled Up.
Steps
1. Use the included screws to install the outer bracket to the rail.
138 Replace the Rail Kit
To Next Page
Loading...
