Embedded module LEDs
Use the fault LEDs to identify the faulted part.
Figure 66. Embedded module LEDs
Table 5. Embedded module LEDs
LED Location State Description
Unsafe to remove White Do not remove the node. Improper
removal could cause data loss.
Off Safe to remove the node when the node
has been properly prepared.
Node power Green Node is on (main power).
Green blinking Node is initializing a serial over LAN
session.
Off Node is off.
Node fault Amber Fault has occurred.
Blue Node in Degraded Mode.
Amber or blue
blinking
System is booting.
Blue and amber
alternating (green
for 3 seconds)
System uninitialized. A management IP
address has not been assigned.
Blue and amber
alternating at one
second intervals
Node in Service Mode.
Port link Green Link up with high speed.
Amber Link up with degraded speed.
Off Link down.
Ethernet port activity Amber blinking Port activity.
Off No port activity.
Ethernet port link Green Link established.
Off No link established.
2-port 100GbE card port link Green Link established.
Off No link established.
Embedded module fault Amber Embedded module has faulted.
Off No fault has occurred, normal operation.
2-port 100GbE card port activity Green blinking Port activity.
Base enclosure service procedures 69
To Next Page
Loading...
