● One MicroUSB-B console port
● One RJ45 serial console port
● One serial management USB Type-A port for more file storage
● Onboard Rangeley central processing unit (CPU) system with 8 GB DDR III RAM, 16 GB iSLC mSATA SSD
● One 10/100/1000BaseT Ethernet management port
● Two hot-swappable redundant power supply units (PSUs)
● Four hot-swappable fan modules
● Standard 1U chassis
The following lists the individual Dell PowerSwitch S5048–ON hardware components that are available for ordering:
● Fan with airflow from I/O side to PSU side—red indicator is normal air flow direction.
● Fan with airflow from PSU side to I/O side—blue indicator is reversed air flow direction.
● AC Power supply with airflow from I/O side to PSU side
● AC Power supply with airflow from PSU side to I/O side
NOTE: Fan modules and power supplies are field replaceable units.
NOTE: All fans and PSUs MUST have the same airflow direction. If you mix the airflow direction, to avoid heat damage to
the switch components, you must correct the mixed airflow direction.
Firmware requirements
The following table lists the minimum release requirements for the switch:
Table 2. Minimum firmware requirements
Firmware Minimum Release Requirement
ONIE FW Updater v3.38.5.1-2
ONIE Version v3.38.1.1-2
BIOS v3.38.0.1-3
CPLD v1.0, 1.0, 1.0, 1.0
SMF MSS v1.4
SMF FPGA v0.1
OOB FPGA v1.0
EEPROM v01
NOTE: Before deploying your switch, Dell Technologies recommends that you check and install the latest firmware or
software images available for upgrade. This upgrade ensures that you get access to the most complete feature set.
The following table lists the latest and previous firmware release versions for the switch:
Table 3. Latest and previous firmware requirements
Firmware Latest Release Version Previous Release Version
ONIE FW Updater v3.38.5.1-5 v3.38.5.1-3
ONIE Version v3.38.1.1-2 v3.38.1.1-2
BIOS v3.38.0.1-6 v3.38.0.1-4
CPLD v1.0, 1.0, 1.0, 1.0 v1.0, 1.0, 1.0, 1.0
SMF MSS v1.4 v1.4
SMF FPGA v0.1 v0.1
OOB FPGA v1.0 v1.0
EEPROM v01 v01
2
To Next Page
Loading...
