Dell PowerVault LTO - Rack Mount Drive Specifications

Table 12. TapeAlert Flags and Descriptions (continued)
TapeAlert Flags Supported by the Tape Drive
31 1Fh Hardware B Set when the tape drive fails
its internal self tests.
Use the error code on
the single-character display,
library user interface, or
SCSI drive sense data. See
“Descriptions and corrective
actions” on page 38.
32 20h Interface Set when the tape drive
detects a problem with
the SCSI or LDI (RS-422)
interface.
Locate error code 8 or 9 in
“Descriptions and corrective
actions” on page 38.
33 21h Eject media Set when a failure occurs
that requires you to unload
the cartridge from the drive.
Unload and reload the tape
cartridge.
34 22h Download fail Set when a eld microcode
replacement (FMR) image is
unsuccessfully downloaded
to the tape drive via the SAS
interface.
Ensure that it is the correct
image. Download the FMR
image again.
35 23h Drive humidity Sets when the drive
humidity sensor indicates
that the drive's humidity
exceeds the recommended
humidity of the drive.
See error code 1 in
“Descriptions and corrective
actions” on page 38.
36 24h Drive temperature Set when the drive's
temperature sensor
indicates that the
drive's temperature
is exceeding the
recommended temperature
of the system (see “General
specications” on page
51).
See error code 1 in
“Descriptions and corrective
actions” on page 38.
37 25h Drive voltage Set when the drive
detects that the externally
supplied voltages are either
approaching the specied
voltage limits or are outside
the voltage limits (see
“General specications” on
page 51).
See error code 2 in
“Descriptions and corrective
actions” on page 38.
39 27h Diagnostics required Set when the drive detects
a failure that requires
diagnostics to isolate the
problem.
See error code 6 in
“Descriptions and corrective
actions” on page 38.
51 33h Tape directory invalid
at unload
Set when the tape directory
on the tape cartridge that
was previously unloaded is
corrupted. The le-search
performance is degraded.
Rebuild the tape directory
by reading all the data.
Chapter 4. Troubleshooting 49