16 Troubleshooting the SMI-S Provider
Turning the Linux system off, takes a long
time.
No action recommended. Exiting the SMI
provider can take up to 15 minutes in
Linux environments.
The CIM client methods fail due to
authentication error or “Return Code
-4”.
During installation, you do not run into
any issues with the storage array password
because the SMI-S Provider does not yet
have information about the storage arrays
to manage. However, after you add the
storage arrays, a Return Code - 4
message is displayed for any method that
runs. A specific error message is not
displayed other than the return value, but
the SMI-S Provider trace log shows that
the method failed because of an
authentication failure. Update the
Property - Secret with the current storage
array password in the
<OEM>SharedSecret instance by using
Modify Instance CIM. You can perform
this operation from the client used for
communicating with SMI-S Provider (for
example, CIM Navigator).
The following message is displays when
you use the CIM CLI application:
roundTripTime is incorrect in
ClientOpPerformanceData
You can ignore this message when using
the CIM command line interface.
Table 4-1. Common Issues and Resolutions
(continued)
Issue Recommended Action
book.book Page 16 Friday, July 9, 2010 2:13 PM
To Next Page
Loading...
