Dell PowerVault MD3220 - Firmware Compatability Levels; Commands Listed by Function; Disk Group Commands

108 Script Commands
On Microsoft Windows, you must put a backslash (\) before and after the
name in addition to other delimiters. For example, the following name is
used in a command running under a Windows operating system:
[\"Engineering"\]
For Linux, and when used in a script file, the name appears as the
following:
["Engineering"]
When you enter the World Wide Identifier (WWID) of an HBA host
port, some usages require quotation marks around the WWID. In
other uses, you must put angle brackets (< >) around the WWID.
The description of the
WWID parameter tells you if you must put
quotation marks or angle brackets around the WWID.
• Script commands must end with a semicolon (;). You can enter more than
one script command on the command line each time you enter a CLI
command.
Firmware Compatability Levels
The RAID controller module firmware for commands is 7.70.
Commands Listed by Function
This section presents the commands organized into groups related to
physical, logical, and operational features of the storage array.
Disk Group Commands
"Create Disk Group" on page 123
"Delete Disk Group" on page 151
"Enable Disk Group Security" on page 164
"Revive Disk Group" on page 179
"Set Disk Group" on page 187
"Set Disk Group Forced State" on page 188
"Show Disk Group" on page 225
book.book Page 108 Friday, March 4, 2011 10:45 AM