Dell PowerVault MD3220 - Create Host Group; Create Host Port

Script Commands 129
NOTE: You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Create Host Group
This command creates a new host group.
Syntax
create hostGroup userLabel="hostGroupName"
Parameter
Create Host Port
This command creates a new HBA host port identification. The identification
is a software value that represents the physical HBA host port to the RAID
controller module. Without the host port identification, the RAID controller
module cannot receive instructions or data from the host port.
hostType The index label or the index number that identifies
the host type. Use the show storageArray
hostTypeTable
command to generate a list of
available host type identifiers. If the host type has
special characters, enclose the host type in double
quotation marks (“ ”).
Parameter Description
userLabel Name to give the host group that you are
creating. You must put quotation marks (" ")
around the host group name.
Parameter Description
book.book Page 129 Friday, March 4, 2011 10:45 AM