Script Commands 161
Parameters
Download Storage Array Firmware/NVSRAM
This command downloads firmware and, optionally, NVSRAM values for the
RAID controller module in the storage array. If you want to download only
NVSRAM values, use the downLoad storageArray NVSRAM command.
Syntax
download storageArray firmware [, NVSRAM ]
file="filename" [, "NVSRAM-filename"]
[downgrade=(TRUE | FALSE)]
[activateNow=(TRUE | FALSE)]
Parameters
Parameter Description
physicalDisk Physical disk to which to download the
firmware image. Specify the enclosure ID
and slot ID for the physical disk.
Enclosure ID values are 0 to 99. Slot ID
values are 0 to 31. You must put brackets
([ ]) around the enclosure ID value and
slot ID value.
filename File path and file name of the file that
contains the firmware image. You must
put quotation marks (" ") around the
firmware image file path and file name.
Parameter Description
NVSRAM Specifies that you want to download a file
with NVSRAM values when you
download a firmware file. You must not
put brackets around this parameter.
Include a comma after the term firmware.
file File path and name of the file that contains
the firmware. Valid file names must end
with a .dlp extension. You must put
quotation marks (" ") around the file name.
book.book Page 161 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
