Dell PowerVault MD3220 - Configuration: Premium Feature-Upgrading to High-Performance-Tier

Script Commands 165
The RAID controller module firmware creates a lock that restricts access to
the SED physical disks. SED physical disks have a state called Security
Capable. When you create a security key, the state is set to Security Enabled,
which restricts access to all SED physical disks that exist within the storage
array.
Enable RAID Controller Module Data Transfer
This command revives a RAID controller module that quiesces while running
diagnostics.
Syntax
enable controller [(0 | 1)] dataTransfer
Parameter
Enable Storage Array Feature
This command enables a premium feature using a feature key file.
Syntax
enable storageArray [featurePack | feature]
file=”filename”
Parameter Description
controller RAID controller module that you want to
revive. Valid RAID controller module
identifiers are 0 or 1, where, 0 is the RAID
controller module on the left and 1 is the
RAID controller module on the right
when viewed from the rear of the
enclosure. You must put brackets ([ ])
around the RAID controller module
identifier. If you do not specify a RAID
controller module, the storage
management software returns a syntax
error.
book.book Page 165 Friday, March 4, 2011 10:45 AM