Script Commands 177
Parameter
Additional Information
The RAID controller module that receives the reset RAID controller module
command resets the RAID controller module specified. For example, if the
reset RAID controller module command is sent to RAID controller module 0
to request a reset of RAID controller module 0, then RAID controller module
0 reboots itself by doing a soft reboot. If the reset RAID controller module
command is sent to RAID controller module 0 to request a reset of RAID
controller module 1, then RAID controller module 0 holds RAID controller
module 1 in reset and then releases RAID controller module 1 from reset,
which is a hard reboot. A soft reboot in some products only resets the IOC
chip. A hard reboot resets both the IOC chip and the expander chips in the
RAID controller module.
Reset Storage Array Battery Install Date
This command resets the age of the batteries in a storage array to zero days.
You can reset the batteries for an entire storage array or just the battery for a
specific RAID controller module or in a specific battery pack.
Syntax
reset storageArray batteryInstallDate controller=
(0 | 1)
Parameter Description
controller RAID controller module to reset. Valid RAID controller
module identifiers are 0 or 1, where, 0 is the RAID controller
module on the left and 1 is the RAID controller module on
the right when viewed from the rear of the enclosure. You
must put brackets ([ ]) around the RAID controller module
identifier. If you do not specify an owner, the RAID controller
module firmware returns a syntax error.
book.book Page 177 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
