Dell PowerVault MD3220 - Set Disk Group

Script Commands 187
• The persistent registration information and the persistent reservation
information
• Detailed information about the current status of the storage array
• The diagnostic data for the physical disk
• A recovery profile for the storage array
• The unreadable sectors that are detected on the storage array
• The state capture data
• An inventory of the versions of the firmware running on the RAID
controller modules, the physical disks, and the RAID controller modules
Syntax
save storageArray supportData file="filename"
Parameter
Set Disk Group
This command defines the properties for a disk group.
Syntax
set diskGroup [diskGroupName]
addPhysicalDisks=(enclosureID1,slotID1
enclosureID2,slotID2 ... enclosureIDn,slotIDn)
Parameters
Parameter Description
file Name of the file to which to save the storage array
support-related data. You must put quotation marks
(" ") around the file name.
Parameter Description
diskGroup Sequence number of the disk group for which to set properties.
You must put brackets ([ ]) around the disk group number.
book.book Page 187 Friday, March 4, 2011 10:45 AM