Dell PowerVault MD3220 - Set Host Channel

192 Script Commands
NOTE: When you use this command, you can specify one or more of the optional
parameters. You do not, however, need to use all of the parameters.
NOTE: You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Set Host Channel
This command defines the loop ID for the host channel.
userLabel The new host name. Enclose the host name in double quotation
marks (" ").
hostType The index label or number of the host type for the HBA host port.
Use the show storageArray hostTypeTable command to generate a list
of available host type identifiers. If the host type has special
characters, enclose it in double quotation marks (" ").
Host Group Parameter Host Has Individual Virtual
Disk-to-LUN Mappings
Host Does Not Have Individual
Virtual Disk-to-LUN Mappings
hostGroupName The host is removed from
the present host group and is
placed under the new host
group defined by
hostGroupName.
The host is removed from the
present host group and is
placed under the new host
group defined by
hostGroupName.
none The host is removed from
the host group as an
independent partition and is
placed under the root node.
The host is removed from the
present host group and is
placed under the default
group.
defaultGroup The command fails. The host is removed from the
present host group and is
placed under the default
group.
Parameter Description
book.book Page 192 Friday, March 4, 2011 10:45 AM