Script Commands 201
ethernetPort The attributes (options) for the management
Ethernet ports. The entries to support this
parameter are listed in the Syntax Element
Statement Data table that follows. Many settings
are possible, including setting the IP address, the
gateway address, and the subnet mask address.
globalNVSRAMByte A portion of the RAID controller module NVSRAM.
Specify the region to be modified using the starting
byte offset within the region and the size and value of
the new data to be stored into the NVSRAM.
hostNVSRAMByte The NVSRAM for the host-specific region. The
setting specifies the host index for the specific
host, the starting offset within the region, the
number of bytes, and the values to be written.
IPv4GatewayIP The IP address of the node that provides the interface
to the network. The address format for the IPv4
gateway is (0–255).(0–255).(0–255).(0–255).
IPv6RouterAddress The IP address of IPv6 router that connects two or
more logical subnets. The address format for the
IPv6 router is (0–FFFF):(0–FFFF):(0–FFFF):(0–
FFFF): (0–FFFF):(0–FFFF):(0–FFFF):(0– FFFF).
iscsiHostPort The values that support this parameter are listed in
the Syntax Element Statement Data table that
follows. Many settings are possible, including
setting the IP address, the gateway address, the
subnet mask address, the IPv4 priority, and the
IPv6 priority.
rloginEnabled The setting for whether the remote login feature is
turned on or turned off. To turn on the remote
login feature, set this parameter to TRUE. To turn
off the remote login feature, set this parameter to
FALSE.
serviceAllowedIndicator The setting for whether the Service Action Allowed
indicator light is turned on or turned off. To turn
on the Service Action Allowed indicator light, set
this parameter to on. To turn off the Service Action
Allowed indicator light, set this parameter to off.
Parameter Description
book.book Page 201 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
