Dell PowerVault MD3220 - Set Storage Array Enclosure Positions

Script Commands 211
Media Scan Rate
Media scan runs on all of the virtual disks in the storage array that have
optimal status, do not have modification operations in progress, and have the
mediaScanRate parameter enabled. Use the set virtualDisk command to
enable or disable the mediaScanRate parameter.
NOTE: If you are using self encrypting disk physical disks in your storage array, you
must use these criteria for your storage array password.
NOTE: You must set a password for your storage array before you can create a
security key for encrypted self encrypting disk physical disks.
Set Storage Array Enclosure Positions
This command defines the position of the enclosures in a storage array. You
must include all of the enclosures in the storage array when you enter
this command.
Syntax
set storageArray enclosurePositions=(controller |
enclosureID... enclosureIDn)
Parameter
Parameter Description
enclosurePostions A list of all of the enclosure IDs. The sequence of the
enclosure IDs in the list defines the positions for the
RAID enclosure and the expansion enclosures in a
storage array. Valid values are 0 to 99. Enter the
enclosure ID values separated by a space. Enclose the list
of enclosure ID values in parentheses. For storage arrays
where the RAID enclosure has a predefined identifier
that is not in the range of valid enclosure position values,
use the controller value.
book.book Page 211 Friday, March 4, 2011 10:45 AM