Script Commands 219
segmentSize=segmentSizeValue
userLabel=virtualDiskName
preReadRedundancyCheck=(TRUE | FALSE)
Syntax Applicable to Virtual Disk Mapping
set (virtualDisk [“virtualDiskName”] | virtualDisk
<wwID> |
accessVirtualDisk)
logicalUnitNumber=LUN
(host=”hostName” | hostGroup=(“hostGroupName” |
defaultGroup)
Parameters
Parameter Description
allVirtualDisks Specifies the properties for all virtual disks in
the storage array.
virtualDisk or
virtualDisks (name)
Specifies the name of the virtual disk for
which to define properties. You can enter
more than one virtual disk name if you use the
virtualDisks parameter. You must put
quotation marks (" ") and brackets ([ ])
around the virtual disk name. The virtual disk
name and quotation marks must be inside the
brackets.
virtualDisk Specifies the WWID of the virtual disk for
which you are setting properties. You can use
the WWID instead of the virtual disk name to
identify the virtual disk. You must put angle
brackets (< >) around the WWID.
cacheFlushModifier The maximum amount of time that data for
the virtual disk stays in cache before the data
is flushed to physical storage. Valid values are
listed in the Notes section.
book.book Page 219 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
