Dell PowerVault MD3220 - Show Disk Group Import Dependencies

226 Script Commands
Parameter
Show Disk Group Import Dependencies
This command shows a list of dependencies for the physical disks in a disk
group that you want to move from one storage array to a second storage array.
Syntax
show diskGroup [diskGroupName] importDependencies
[cancelImport=(TRUE | FALSE)]
Parameters
NOTE: This command returns the dependencies of a specific disk group, which
must be in an Exported state or a Forced state. If a decision is made to retain the
listed dependencies, then the
cancelImport parameter can be enforced to spin the
physical disks back down. You must run the show diskGroup importDependencies
command before you run the start diskGroup import command.
Parameter Description
diskGroup Number of the disk group for which to display
information. You must put brackets ([ ]) around
the disk group number.
Parameter Description
diskGroup Number of the disk group for which to display
information. You must put brackets ([ ]) around
the disk group number.
cancelImport The setting to spin the physical disks back down
after the disk group dependencies have been
read. To spin down the physical disks, set this
parameter to TRUE. To let the physical disks
stay spinning, set this parameter to FALSE.
book.book Page 226 Friday, March 4, 2011 10:45 AM