60 Configuring a Storage Array
The following syntax is the general form of the command:
set (physicalDisk [enclosureID,slotID] |
physicalDisks [enclosureID0,slotID0 ...
enclosureIDn,slotIDn] hotSpare=(TRUE | FALSE)
The following example shows how to use this command to set hot spare
physical disks:
client>smcli 123.45.67.89 -c "set physicalDisks
[0,2 0,3] hotSpare=TRUE;"
Enter the enclosure ID and slot ID of each physical disk that you want to use.
You must put brackets ([ ]) around the list. Separate the enclosure ID and
slot ID of a physical disk by a comma. Separate each enclosure ID and slot ID
pair by a space.
book.book Page 60 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
