74 Configuration: About Your Storage Array
To change the enclosure order in the physical pane:
1
In the AMW, select
Storage Array
Change
Enclosure Order
.
2
From the enclosures list, select the enclosure you want to move and click
either
Up
or
Down
to move the enclosure to the new position.
3
Click
OK
.
4
If you have set a password for the selected storage array, the
Enter
Password
dialog appears. Type the current password for the storage array.
5
Click
OK
.
Configuring Alert Notifications
MDSM can send an alert for any condition on the storage array that requires
your attention. Alerts can be sent as e-mail messages or as Simple Network
Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single
storage array.
To configure alert notifications for all storage arrays:
1
In the EMW, select the
Setup
tab.
2
Select
Configure Alerts
.
The
Configure Alerts
dialog is displayed.
3
Select
All storage arrays
.
4
Click
OK
.
The
Configure Alerts
dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 75. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 77.
To configure alert notifications for a single storage array:
1
In the EMW, select the
Devices
tab.
2
Select the relevant storage array, then select
Edit
Configure Alerts
.
The
Configure Alerts
dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 75. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 77.
book.book Page 74 Monday, June 21, 2010 11:00 AM
To Next Page
Loading...
