142 Configuration: Disk Groups and Virtual Disks
Importing a Disk Group
NOTE: You must insert all of the physical disks that are part of the disk group into
the enclosure before the disk group can be imported.
On the target storage array:
1
Insert the exported physical disks into the available physical disk slots.
2
Review the Import Report for an overview of the disk group that you are
importing.
3
Check for non-importable components.
4
Confirm that you want to proceed with the import procedure.
NOTE: Some settings cannot be imported during the import disk group
procedure.
The following settings are removed/cleared during the procedure:
• Persistent reservations
• Host-to-virtual disk mappings
• Virtual disk copy pairs
• Snapshot virtual disks and snapshot repository virtual disks
• Remote replication pairs
• Replication repositories
Non-Importable Components
Some components cannot be imported during the import disk group
procedure. These components are removed during the procedure:
• Persistent reservations
• Host-to-virtual disk mappings
• Virtual disk copy pairs
• Snapshot virtual disks and snapshot repository virtual disks
• Remote replication pairs
• Replication repositories
book.book Page 142 Friday, September 23, 2011 2:46 PM
To Next Page
Loading...
