182 Configuration: Premium Feature—Virtual Disk Copy
Removing Copy Pairs
You can remove one or more virtual disk copies by using the Copy Manager.
Any virtual disk copy-related information for the source virtual disk and the
target virtual disk is removed from the Virtual Disk Properties dialog and the
Storage Array Profile dialogs. When you remove a virtual disk copy from the
storage array, the Read-Only attribute for the target virtual disk is also removed.
After the virtual disk copy is removed from the Copy Manager, you can either
select the target virtual disk as a source virtual disk or the target virtual disk for
a new virtual disk copy. If you remove a virtual disk copy, the source virtual disk
and the target virtual disk are no longer displayed in the Copy Manager.
Keep these guidelines in mind when you remove copy pairs:
• Removing copy pairs does not delete the data on the source virtual disk or
target virtual disk.
• If the virtual disk copy has a status of
In Progress
, you must stop the
virtual disk copy before you can remove the copy pair.
To remove copy pairs:
1
In the AMW, select
Virtual Disk
Copy Manager
.
The
Copy Manager
window is displayed.
2
In the table, select one or more copy pairs.
3
Select
Copy
Remove Copy Pairs
.
The
Remove Copy Pairs
dialog is displayed.
4
Click
Yes
.
book.book Page 182 Friday, September 23, 2011 2:46 PM
To Next Page
Loading...
