Configuration: About Your Host 93
Creating a Host Group
1
In the AMW, select the
Mappings
tab.
2
In the
Topology
pane, select the storage array or the
Default Group
.
3
Perform one of the following actions:
• Select
Mappings
Define
Host Group
• Right-click the storage array or the
Default Group,
and select
Define
Host Group
from the pop-up menu.
4
Type the name of the new host group in
Enter new host group name
.
5
Select the appropriate hosts in the
Select hosts to add
area.
6
Click
Add
.
NOTE: To remove hosts, select the hosts in the Hosts in group area, and click
Remove.
7
Click
OK
.
The host group is added to the storage array.
Adding a Host to a Host Group
You can add a host to an existing host group or a new host group using the
Define Host Wizard. For more information, see "Defining a Host" on
page 90.
You can also move a host to a different host group. For more information, see
"Moving a Host to a Different Host Group" on page 94.
Removing a Host From a Host Group
You can remove a host from the Topology pane on the Mappings tab of the
Array Management Window. For more information, see "Removing a Host
Group" on page 94.
book.book Page 93 Friday, September 23, 2011 2:46 PM
To Next Page
Loading...
