40 Post Installation Tasks
If you are using a DHCP server:
1
In the
Control Panel
, select
Network connections
or
Network and
Sharing Center
and then click
Manage network connections
.
2
Right-click the network connection you want to configure and
select
Properties
.
3
On the
General
tab (for a local area connection) or the
Networking
tab
(for all other connections), select
Internet Protocol (TCP/IP)
, and then
click
Properties
.
4
Select
Obtain an IP address automatically
, then click
OK
.
If you are using static IP addressing:
1
In the
Control Panel
, select
Network connections
or
Network and Sharing
Center
and then click
Manage network connections
.
2
Right-click the network connection you want to configure and select
Properties
.
3
On the
General
tab (for a local area connection) or the
Networking
tab
(for all other connections), select
Internet Protocol (TCP/IP)
, and then
click
Properties
.
4
Select
Use the following IP address
and enter the IP address, subnet mask,
and default gateway addresses.
If you are using a DNS server:
1
In the
Control Panel
, select
Network connections
or
Network and Sharing
Center
and then click
Manage network connections
.
2
Right-click the network connection you want to configure and select
Properties
.
3
On the
General
tab (for a local area connection) or the
Networking
tab
(for all other connections), select
Internet Protocol (TCP/IP)
, and then
click
Properties
.
4
Select
Obtain DNS server address automatically
or enter the preferred
and alternate DNS server IP addresses and click
OK
.
If you are using a WINS server:
NOTE: If you are using a DHCP server to allocate WINS server IP addresses, you
do not need to add WINS server addresses.
1
In the
Control Panel
, select
Network connections
.
book.book Page 40 Wednesday, December 29, 2010 9:23 PM
To Next Page
Loading...
