Dell PowerVault MD3600i - Page 72

72 Appendix—Manual Configuration of iSCSI
discovery.sendtargets.auth.password_in =
<CHAP_target_password>
7
The final configuration contained in the /etc/iscsi/iscsid.conf file might
look like this:
node.session.auth.authmethod = CHAP
node.session.auth.username = iqn.2005-
03.com.redhat01.78b1b8cad821
node.session.auth.password = password_1
node.session.auth.username_in= iqn.1984-
05.com.dell:powervault.123456
node.session.auth.password_in = test1234567890
discovery.sendtargets.auth.authmethod = CHAP
discovery.sendtargets.auth.username = iqn.2005-
03.com.redhat01.78b1b8cad821
discovery.sendtargets.auth.password = password_1
discovery.sendtargets.auth.username = iqn.1984-
05.com.dell:powervault.123456
discovery.sendtargets.auth.password_in =
test1234567890
If you are using SUSE Linux Enterprise Server SP3 using the GUI:
1
Click Desktop  YaS T  iSCSI Initiator .
2 Click Service Start , then select When Booting .
3 Select Discovered Targets , then select Discovery .
4 Enter the IP address of the port.
5 Click Next .
6 Select any target that is not logged in and click Log in .
book.book Page 72 Wednesday, December 29, 2010 9:23 PM