Power Management
Fan Control Override Controls the speed of the system fan. This option is disabled by
default.
NOTE: When enabled, the fan runs at full speed.
Wake on LAN This option allows the computer to power up from the off state
when triggered by a special LAN signal. Wake-up from the
Standby state is unaffected by this setting and must be enabled
in the operating system. This feature only works when the
computer is connected to AC power supply.
• Disabled - Does not allow the system to power on by special
LAN signals when it receives a wake-up signal from the
LAN or wireless LAN.
• LAN Only - Allows the system to be powered on by special
LAN signals.
This option is Disabled by default.
POST Behavior
Numlock LED Enables or disables the Numlock feature when your computer
starts. When enabled (default), this option activates the
numeric and mathematical features shown at the top of each
key. When disabled, this option activates the cursor-control
functions labeled on the bottom of each key.
Keyboard Errors Enables or disables keyboard error reporting when the
computer starts. This option is enabled by default.
POST Hotkeys Allows you to specify the function keys to display on the
screen when the computer starts.
Enable F2 — Setup (enabled by default)
Enable F12 — Boot menu (enabled by default)
Fast Boot When enabled (default), your computer starts more quickly
because it skips certain configurations and tests.
Virtualization Support
Virtualization This option specifies whether a Virtual Machine Monitor
(VMM) can utilize the additional hardware capabilities
62
To Next Page
Loading...
