Dell Studio XPS 9100 - Power Supply; Removing the Power Supply

Back to Contents Page
 Power Supply
Dell™StudioXPS™9100ServiceManual
Removing the Power Supply
Replacing the Power Supply

Removing the Power Supply

1. Follow the instructions in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Disconnect the DC power cables from the system board and the drives (see System Board Components).

4. Release all cables from the securing clip on the bottom of the power supply.

5. Remove the four screws that secure the power supply to the chassis.

6. Press the tab and slide the power supply towards the front of the computer.

7. Lift the power supply away from the chassis.
Replacing the Power Supply

1. Follow the instructions in Before You Begin.

2. Slide the power supply towards the back of the chassis.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
1
tab
2
power supply
3
screws (4)