9. Place the alignment bar in the chassis.
10. Replace the screw that secures the alignment bar to the chassis.
11. Pivot the expansion card retainer towards the alignment bar until it snaps into place.
12. Replace the computer cover (see Replacing the Computer Cover).
13. Connect your computer and devices to electrical outlets, and turn them on.
14. Flash the system BIOS, as needed.
Entering the Service Tag in the BIOS
1. Turn on the computer.
2. Press <F2> during POST to enter the System Setup program.
3. Navigate to the System Info tab and enter the Service Tag in the Set Service Tag field.
Back to Contents Page
To Next Page
Loading...
