1. Follow the instructions in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
3. Locate the 3-pin CMOS reset jumper (CLR_CMOS) on the system board (see System Board Components).
4. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
5. Wait for approximately five seconds to clear the CMOS setting.
6. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
7. Replace the computer cover (see Removing the Computer Cover).
8. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
To Next Page
Loading...
