About this task
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE: The M.2 card installed on your computer will depend on the configuration ordered. The supported card
configurations on the M.2 card slot are:
● M.2 2230 solid-state drive + 2230 mounting bracket
● M.2 2280 solid-state drive
The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
removal procedure.
Steps
1. Peel the Mylar that covers the system board.
2. Remove the screw (M2x3) that secures the M.2 2230 bracket to the system board.
3. Slide and lift the M.2 2230 bracket off the system board.
4. Slide and lift the M.2 2230 solid-state drive off the system board.
16
Removing and installing components
To Next Page
Loading...
