About this task
The following image(s) indicate the location of the power-button and provides a visual representation of the installation
procedure.
Steps
Using the alignment posts, place the power-button with optional fingerprint reader into its slot on the palm-rest and keyboard
assembly.
Next steps
1. Install the heat sink (integrated graphics) or the heat sink (discrete graphics), whichever applicable.
2. Install the IO board.
3. Install the left fan.
4. Install the base cover.
5. Exit Service Mode.
6. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power-button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
4. Remove the left fan.
5. Remove the I/O board.
6. Remove the heat sink (integrated graphics) or the heat sink (discrete graphics), whichever applicable.
About this task
The following image(s) indicate the location of the power-button with fingerprint reader and provides a visual representation of
the removal procedure.
48
Removing and installing components
To Next Page
Loading...
