Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the
installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
Next steps
1. Install the system board.
2. Install the power button or the power button with fingerprint reader, whichever applicable.
3. Install the IO board.
4. Install the display assembly.
5. Install the touchpad.
6. Install the left fan.
7. Install the right fan.
8. Install the wireless card.
9. Install the battery.
10. Install the base cover.
11. Follow the procedure in After working inside your computer.
Removing and installing components
55
To Next Page
Loading...
