28 Solid-State Drive
3
Slide and remove the solid-state drive out of the system-board connector.
Replacing the Solid-State Drive
1
Align the notch on the solid-state drive with the tab in the
system-board connector.
CAUTION: Use firm and even pressure to slide the solid-state drive into place.
If you use excessive force, you may damage the connector.
2
Insert the solid-state drive connector at a 45-degree angle into the
system-board connector.
3
Replace the screw that secures the solid-state drive to the system board.
4
Adhere the tape over the solid-state drive.
Postrequisites
1
Replace the battery. See "Replacing the Battery" on page 18.
2
Replace the power-light board. See "Replacing the Power-Light Board" on
page 16.
3
Replace the base cover. See "Replacing the Base Cover" on page 14.
4
Follow the instructions in "After Working Inside Your Computer" on page 11.
1 screw 2 system-board connector
3 solid-state drive
OM_Book.book Page 28 Tuesday, September 25, 2012 2:30 PM
To Next Page
Loading...
