Power-Adapter Connector 37
Replacing the Power-Adapter Connector
1
Align the screw hole on the power-adapter connector with the screw hole
on the palm-rest assembly.
2
Replace the screw that secures the power-adapter connector to the
palm-rest assembly.
3
Route the power-adapter connector cable through the routing guides
on the fan.
4
Connect the power-adapter connector cable to the system-board connector.
5
Route the mini-card cables through the routing guides.
6
Slide the touchpad cable into the system-board connector and press
down on the connector latch to secure the cable.
1 routing guides 2 screw
3 power-adapter connector cable
OM_Book.book Page 37 Tuesday, September 25, 2012 2:30 PM
To Next Page
Loading...
