Steps
1. Remove the screw (M2x3) that secures the M.2 solid-state drive shield to the system board.
2. Slide the M.2 solid-state drive shield off the system board.
3. Slide the M.2 2230 solid-state drive out of the solid-state drive slot.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
22
Removing and installing components
To Next Page
Loading...
