book.book Page 31 Monday, June 25, 2012 11:55 AM
2 Lift the connector latch and, using the pull-tab, disconnect the optical-drive cable
from the system board.
3 Peel the optical-drive cable from the fan.
4 Remove the coin-cell-battery cable from the routing guides on the
optical-drive bracket.
5 Remove the screw that secures the optical-drive assembly to the palm-rest assembly.
6 Lift the optical-drive assembly at an angle and release it from the tab on the
palm-rest assembly.
1 tab 2 optical-drive assembly
3 screw 4 coin-cell-battery cable
5 fan 6 routing guide
7 optical-drive cable 8 pull-tab
9 connector latch
Removing the Optical Drive | 31
To Next Page
Loading...
