Dell XPS 17 9720 - Removing and installing components

Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx #5 (T5) screwdriver
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
Base cover M2x4 8
Battery M2x4 7
Solid-state drives M2x4 2
Right fan
● M2x4
● M1.6x4
● 2
● 1
●
●
Left fan
● M2x4
● M1.6x4
● 2
● 1
●
●
Heat sink (Integrated graphics) Captive 4
Heat sink (Discrete graphics) Captive 7
2
Removing and installing components 9