5. Press and hold the power button for 20 seconds to ground the computer and drain the flea power.
Installing the base cover
Prerequisites
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
Steps
1. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the
base cover into place.
2. Replace the eight Torx T5 screws (M2x4) to secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in After working inside your computer.
14
Removing and installing components
To Next Page
Loading...
