Steps
1. Connect the fan cable to the system board.
2. Align the screw holes on the fan with the screw holes on the system board and palm-rest and keyboard assembly.
3. Replace the two screws (M2x4) and the single screw (M1.6x4) to secure the fan to the system board and palm-rest and
keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the left fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image indicates the location of the left fan and provides a visual representation of the removal procedure.
Removing and installing components
23
To Next Page
Loading...
