7. Install the solid-state drive.
8. Install the memory module.
9. Install the battery.
10. Install the base cover.
11. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the memory module.
5. Remove the solid-state drive.
6. Remove the heat sink.
7. Remove the right fan.
8. Remove the left fan.
9. Remove the audio-daughter board.
10. Remove the display assembly.
11. Remove the system board.
12. Remove the antennas.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the removal
procedure.
After performing the steps in the pre-requisites, you are left with the palm-rest and keyboard assembly.
Removing and installing components
43
To Next Page
Loading...
