Bluetooth Assembly 69
12
Bluetooth Assembly
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
WARNING: Do not operate your computer with any cover(s) (including computer
covers, bezels, filler brackets, front-panel inserts, etc.) removed.
CAUTION: Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
Removing the Bluetooth Assembly
1
Follow the instructions in "Before You Begin" on page 13.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 17).
3
Remove the front bezel (see "Removing the Front Bezel" on page 27).
4
Disconnect the Bluetooth assembly cable from the system board
connector F_USB4 (see "System Board Components" on page 10).
5
Press in on the tab as shown in the illustration and pull the Bluetooth
assembly away from the front panel.
6
Carefully slide and remove the Bluetooth assembly cable through the slot
in the front panel.
book.book Page 69 Wednesday, April 25, 2012 12:34 PM
To Next Page
Loading...
