Power Button Module 75
Replacing the Power Button Module
1
Follow the instructions in "Before You Begin" on page 13.
2
Align and push the power button module tabs into the slots on the top
panel.
3
Connect the power button module cable to the system board connector,
F_PANEL (see "System Board Components" on page 10).
4
Replace the top cover (see "Replacing the Top Cover" on page 59).
5
Replace the optical drive (see "Replacing the Optical Drive" on page 51).
6
Replace the front bezel (see "Replacing the Front Bezel" on page 29).
7
Replace the computer cover (see "Replacing the Computer Cover" on
page 18).
8
Connect your computer and devices to electrical outlets and turn them on.
book.book Page 75 Wednesday, April 25, 2012 12:34 PM
To Next Page
Loading...
