58 mSATA Drive
Replacing the mSATA Drive
CAUTION: The connectors are keyed to ensure correct insertion. Use of
excessive force may damage the connectors.
CAUTION: To avoid damage to the mSATA drive, ensure that there are no cables
under the mSATA drive.
1
Align the notch on the mSATA drive with the tab in the system-board
connector.
2
Insert the mSATA drive at a 45-degree angle into the system-board
connector.
3
Press the other end of the mSATA drive down into the slot on the system
board and replace the screws that secure the mSATA drive to the system
board.
1 mSATA drive 2 screws (2)
3 notch 4 tab
2
1
3
4
book.book Page 58 Wednesday, April 4, 2012 2:00 PM
To Next Page
Loading...
