Prerequisites
Remove the computer cover.
Procedure
1 Locate the CMOS reset jumper (CMCLR) on the system board.
NOTE: For more information on the location of the CMOS jumper, see
“System-board components”.
2 Remove the jumper plug from the password jumper-pins (PSWD) and connect it
to the CMOS jumper-pins.
3 Wait for 5 seconds and then replace the jumper plug to the password jumper-
pins (PSWD).
1 jumper plug 2 password jumper-pins
(PSWD)
3 CMOS jumper-pins
Post-requisites
Replace the computer cover.
104
To Next Page
Loading...
